Drive the main equipment main motor, the main motor fan, reducer, reducer pump and fan, inverter . The signal acquisition of the main motor is mainly the winding temperature of each phase of the motor, the temperature of the front axle and the rear axle; the speed reducer device mainly detects the temperature of the front axle and the rear axle of the speed reducer; the control line connected with the frequency converter has start- Inverter operation signal, inverter fault signal, inverter voltage and current signals, inverter speed setting signal. Then it is connected with the main motor fan, reducer pump and fan feed switch control line, start and stop signals, operating signals, current signals. Each processor detects and controls the managed drive unit equipment and transmits the signal to the processor to send signals such as motor overtemperature fault, main motor fan operation back fault, inverter fault etc. to the processor and output Protect action. At the same time, there is a DIP switch to select the equipment which is not used in the electric control system of the belt conveyor. For example, if the gear unit oil pump is not available, the corresponding DIP switch will be OFF. Protector module to achieve the belt conveyor along the line, deviation, stacking, longitudinal tear, slipping, over-temperature, registration, speed and other signals collected at the same time through the output protection action. Protector module contains CAN communication interface, through the CAN bus, the cable position, deviation position, belt temperature, belt speed and other information sent to the display module display and the main processor module for processing. Electric Lock,Electric Deadbolt Lock,Electric Door Lock,Electric Strike Lock Dongguan Kaisijin Intelligent Technology Co., Ltd , https://www.dgsmartlockoems.com