When the production line is working on hard solid wood, most of them use the milling process. The machine speed is high, and the wood chips and dust splash are quite serious. The air compressor room of the plant is placed on the side of the end of the production line processing workshop, and the air compressor room is directly connected to the processing workshop. Although two doors were installed, they were open. Therefore, the dust in the workshop is naturally mixed into the machine room. Shortly after the processing line was used, it was found that the air compressor power supply often tripped until it could not be started and affected production. After inspection and analysis, it was found that the air filter installed at the suction end of the air compressor was blocked by wood dust, which caused the air compressor to be inhaled, which caused the cylinder to suck. The filter was carefully cleaned and the air compressor started to operate normally after closing the door. However, in practice, it was found that after the use of the production line for a period of time, the pneumatic components on the equipment continued to malfunction, the most typical of which was a long-stroke gas-liquid damping cylinder used on a wood-turning machine. In less than half a year, the phenomenon of low-speed crawling occurred. After inspection and analysis, it was found that many wood chips and moisture were entered in the cylinder, which caused the relative motion friction surface to be rusted and peeled off. At this time, some pneumatic components were cleaned and replaced, and a gas source purification system was installed, and a primary filtration and degreasing device was added. From then on, the normal operation of the device is ensured. A workshop uses a fully pneumatic liquid filling machine containing xylene volatile gas in the liquid being filled. Therefore, this gas is mixed in the atmosphere of the workshop environment, and it has a serious erosion effect on the rubber seal of the pneumatic component. Round Open Water Cooling Tower The whole structure is solid and light;the body and water pond is manufactured with reinforced glass fibre (FRP glass fiber reinforced plastics),never being corrosive. The surface finish is added with ultraviolet inhibitor,which can resist sunshine attack and damage.
Apply special design PVC water block curtain (water-stop) to prevents plashing) remarkably; pressure drop loss is slight and splashing loss i under 0.001%.
Apply cellular vacuum molding heat dissipation material, stagger arrangement surface has grooves and the heat exchange effect is especially good.
Round Open Water Cooling Tower,Water Cooling Tower,Round Cooling Tower,Cool Water Towers Wuxi Ark Fluid Science Technology Co., Ltd. , https://www.fangzhou-arkfluid.com
All steel and iron material is processed through galvanizing by dipping,Ocorrosion resisting and durable.
Special designed axial-flow type air blower applies belt reduction gear,reducing low noise and sufficient wind; tailor-made water-drop noise
reduction carpet to eliminate water sound.
Water pond applies slant design, easy to wash, containing less water; the operating weight is lower, but the water tank is very big, so it won't absorb air.
The cooling tower support is light and solid, convenient to assembly no matter there is suspension iron rack or not.