This regulation specifies the beneficiation plant vibration to the mining machine contents and requirements for safe operation. This procedure is applicable to the vibration of the concentrator to the mine machine. 2 content 2.1 The operator must be qualified after passing the safety training; wear protective helmets, dust masks, gloves and other labor protection articles before going to work. Employees must wear three tight dresses; women workers must be in safety helmets, not wearing shorts, high heels, and slippers. 2.2 Before starting the vibration feeding machine, check whether there is any obstacle around the mining machine that hinders its operation, whether the vibration motor is normal and reliable, whether the spring is broken or not, and whether the bolt is loose. 2.3 Check if the starting equipment is good and the motor is grounded properly. 2.4 Remove the debris from the vibration to the mining machine slide to avoid heavy load starting. 2.5 Check and tighten the bolts at each part. 2.6 Observe whether the vibration of the vibrating machine is balanced, and there is no impact or friction on the moving parts. 2.7 The feedstock must be uniform, not overloaded or have excessive impact. 2.8 Always pay attention to the temperature and abnormal noise of the vibration motor. 2.9 If there is a crisis in equipment safety and personal safety during operation, the application will be emergency shutdown. 2.10 Vibration to any size repair or adjustment of the miner in operation must be to cut off the power of the machine, and then proceed. 2.11 Vibration during the operation of the mining machine is strictly prohibited to clean the bottom of the base or moving parts. If it needs to be cleaned, it must be stopped. 2.12 It is forbidden to enter the feeding funnel to handle large blocks without authorization. When it is necessary to enter the mine bin and funnel to deal with the fault, the upper and lower machines should stop first, turn the equipment switch to zero position, and hang the warning sign of “someone is working, no closingâ€. When cleaning the mine bin, the bin should be covered by the cover, fasten the seat belt and labor protection supplies. Under the condition of special personnel supervision and good lighting, remove the floating mine and loose the lining in order from top to bottom. Carry out the work and return the facility to its original position after the work is over. 2.13 When using the blasting method to dispose of the dropping funnel, it shall be the responsibility of the professional holding the blasting certificate and strictly implement the relevant specifications of GB-6722. Semi-Auto Carton Packing Machine,Carton Packing Machine,Carton Packing Machines Zhangjiagang Mark Beverage Machinery Co., Ltd. , https://www.markfilling.com
Vibration to mine machine post safety operation procedures
　　 1 Scope